Make a simple and inexpensive DIY Sprinkler made from PVC Pipe. Water your lawn in half the time without a sprinkler system. Enjoy your green lawn.
Man it’s hot outside, and my yard shows it! Yard work is not my favorite thing and our poor lawn has been losing it’s gorgeous green from spring and is starting to look dry and brown. We needed to figure something out for watering. The previous owners put in a sprinkler system but it has never worked, and replacing the whole system is out of our budget.
One of hubby’s friends at work had made a sprinkler out of PVC pipe and hubby was sure he could make one too! We headed to Home Depot and brought back all of our goodies and started building. We went in not knowing exactly what we needed or how to build it, but the Home Depot employee was very helpful so we knew exactly what to do.
I asked my husband if he would help write this post and he said sure. Tell them to go ask a Home Depot employee!
- 10-foot 3/4″ PVC Pipe cut in half (2, 5-foot pieces)
- 2-foot 3/4″ PVC Pipe cut in half (2, 1-foot pieces)
- PVC Pipe Cement
- 2 Sprinkler Heads
- 1 threaded cap
- 2 male thread adapters
- 2 elbows
- 1 cross-section
- 1 hose adapter.
Simple DIY PVC Sprinkler Step by Step Instructions
Start by gluing the longer ends to the cross-section. You want to glue the inside of the piece you are attaching it too and the outside of the pipe that is going into the piece.
Glue the shorter pieces in across from each other using the same method as before into the cross-section.
On one of the short pipes glue on a threaded cap using the same glue method.
On the other end of the short pipe glue the hose adapter making sure the top still rotates freely after you have glued it.
This is what it should look like at this point.
Glue the elbows onto the ends of the long pieces. This is for the sprinkler heads.
Wrap Thread Seal Tape around both male ends of the adapter.
Screw the adapters into the elbow and tighten with adjustable pliers to make it nice and tight.
Screw the sprinkler head into the adapter.
And voilà! You are all done!. The entire project only took about 30-45 minutes plus a bit more for the drying time.
It even works and everything!
The kids thought that they needed to try it out and make sure everything worked OK.
*I tried to use the correct verbiage for all of the different pieces, but this was our first time working with PVC, so if named something wrong I am sorry.*
What have you made out of PVC pipe? I would love for you to share and leave a comment below.