Measure the circumference of the wrist, divide by two and that is the length of chain needed.

Use two pairs of jewelry pliers to open the link, and remove the length needed from the rest of the chain.

Clamp each side of the link with a pair of pliers in each hand, and the twist the wrists in opposite directions to open the link.

In the opening of the link, insert the jelly rubber hair band.

Close the link the same way it was opened, with two pairs of pliers holding each side of the link and twisting the wrists to close the link.

Open the first link in the length of chain, and attach it to the hair band by closing the chain link.

When this bracelet was finished, I forgot to take a picture because I immediately had an idea for another bracelet.

Take another length of chain, the same as the first.

Start on the end of the chain that does not have the open link.

Grab a loom band, flatten so the band is more of a flat oval than a circle, and insert through the closed link at the end of the length of chain.

Push each side of the loom band up.

Insert another band through the two loops of the previous mini band.

Repeat with another mini band through the two loops of the previous mini band.

Keep repeating this with alternating colors until the length of the entire bracelet, chain included, is to the desired length.

Place the last looped loom band in the open link at the end of that chain, and close the link using the same method as above.